1984 Chevy Monte Carlo SS – PRO STREET. This BEAST is a complete frame off custom build which has been 10+ years in the making. The owner has invested over 100K in parts alone, not including the 100’s of labor hours that he spent on the build himself. The meticulous detail that went into this build is what really sets it apart from other “PRO STREET†cars out there today. All the receipts and literature for the installed parts and accessories are available and will be passed onto the buyer. The interior was completely reupholstered floor to ceiling with beautiful blue fabric. Even the rear seat was custom cut and re-installed which is typically not seen on a tubbed car. It has a “Dakota†digital dash that looks like it belongs there from the factory. It gives you a clear view of MPH, RPM’s, fuel percentage, and water temperature. The Hurst shifter is surrounded by a hand-made chromed aluminum console and has a custom made dual switch shift handle for line lock and over drive. The steering wheel is made by “Banjo†and is removable which is a good anti-theft feature. Call, Text or Email Ryan Fallon - 267.228.8150 – Ryanfallon2@gmail.com Now moving to the outside of the vehicle. The frame is straight as an arrow and there is NO rust anywhere. The exterior white paint is flawless and boasts beautiful hand painted decals that really accent nicely the theme of the car. This Monte rides on polished aluminum “Centerline†wheels wrapped in Micky Thompson rubber. It has front 12†and rear 13†disc brakes (with Emergency Brake) for superior stopping ability. This Monte truly rides like a Cadillac with its full front and rear “Hotchkis†suspension and “Strange†axles. Finally, to get into the good stuff. The car is powered by a 502 cubic inch big block crate engine. The heads were ported to match the polished aluminum “Stealth†intake manifold. It has a turbo 350 transmission built for 1000 HP. The transmission has “Gear Venders†for over and under drive to make it a full manual 6-speed. It has a bullet proof 9†rear with 4.11 gear ratio. Nascar radiator with twin fans. Hooker headers with a custom made full stainless steel 3†exhaust. Handmade stainless steel gas tank. Custom made carburetor intake which pulls extra air off the cowl. There’s a A/C idle solenoid to kick up RPM’s when the air conditioner is on. 120 AMP, 1 wire alternator. The battery shuts off with the key. Call, Text or Email Ryan Fallon - 267.228.8150 – Ryanfallon2@gmail.com There are so many custom parts on this Monte that it is nearly impossible to remember them all let alone list them all so I just mentioned a few. The engine dyno-ed out at 605 HP @ 6500 RPM. This car was built for show, not for racing however you could make a few modifications to make it track worthy (roll cage and parachute.) But that would really take from the cars integrity. This Monte Carlo is truly a “Hot Rod Family Car.†It has less than 150 miles on it since it was complete and it has never been raced. It has been entered into many local car shows where it has won award such as “best in show†and “best motor.†Polished aluminum and stainless steel. Almost every bolt under the hood that could be has a Chevy insignia bolt head. It runs on pump gas (93 octane) but will certainly take racing fuel. The car has been garage kept since the build began and has never seen the rain. A little about the owner/builder… This multiple award winning show stopper is owned by and was built by master mechanic Joe “Slim†Ulanowski. He has been building custom/race cars for well over 40 years and his garage Academy Automotive which is located in Northeast Philadelphia has been open since 1976. He has built and restored numerous award winning vehicles in his career. Slim and Academy Automotive are proud sponsors of the wounded warrior project in which “Slim†had his hand in the building of the Wounded Warrior Projects 1969 Chevy Camaro SS.
|